Digital Vernier Calipers 6", 8" or 12" digital calipers with dual metric/imperial readout

Mould Alignment Gauge Set to assist in centralising and vertically setting Thermit moulds

Rail Head Depth Gauge The Rail Head Depth gauge has been developed in collaboration with Network Rail. The development of the gauge follows the introduction of the Thermit® head repair (HRW) process.

Rail Wear Gauge to determine the amount of wear on the head of the rail and the nominal size of new rail

Rolling Contact Fatigue Grinding Gauge Set to measure the amount of material removed from the head & gauge corner when eliminating cracks due to rolling contact fatigue

Square Welders' Extended to set preheaters and align moulds for the Railtech welding process

Square Welders’ Engineers’ to check the squareness of the ends of rail prior to welding and aligning alumino thermic moulds

Stepped Weld Flashing Gauge to check for excess flashing around the weld collar

Straight Edge 4-nibbed for Dipped/Battered Joints 4 nibbed 1 metre straight edge for dipped and battered joints

Straight Edge Insulated Weld Inspectors Insulated Weld Inspectors� Straight Edge for working in 650 - 750 d.c 3rd / 4th rail areas.

Straight Edge Welders' to align rail prior to welding & to check rail surface flatness after grinding

Switch Blade Angle Gauge with Taper Gauge to check the angle on switch blades

Taper Gauge (graduated) used with welders straight edge to check and measure the flatness of the head of the rail

Taper Gauge Peaked and Dipped used with a nibbed straight edge to give a quick indication if the head of the rail is peaked or dipped

Taper Gauge Welders' 'GO' used with welders straight edge to validate the flatness of the head of the rail

Weld Alignment Inspection Gauge to check vertical and horizontal alignment of welds (flat bottom rail only)

Weld Combination Gauge to check foot & web alignment, flatness across the head, rail gall and bolt hole clearance